Office Tel: 0086-532-87786000


Home > Exhibition > Content
Efficient activation of the mixer should be set up
- Jun 10, 2016 -

1, the mixer should be set in a flat position, with square wooden pad from the front and rear axles, the tire placed overhead, so as not to move when moving.


2, the mixer should be implemented two leakage protection, power supply connected to work before, you must carefully check the empty car try to pass that can be used. Test run should check the speed of mixing tube is appropriate, under normal circumstances, the proportion of empty car speed (loading) slightly faster 2 to 3 turn, such as more difference should be adjusted wheel and the proportion of transmission wheel.


3, the rotation direction of the mixing tube should be consistent with the direction of the arrow, if not true, should correct the motor wiring.


4, check the transmission clutch and brake is flexible and reliable, whether the damage to steel wire rope, track pulley is good, around the barrier-free and lubrication of various parts of the situation.


5, boot, always pay attention to the operation of various parts of the mixer is normal. Shutdown, often check whether the mixer blade bending, whether the screw hit or loose.


6, when the concrete mixing is completed or is expected to stop 1h or more, in addition to the remaining material out of the net, the application of stones and water into the shaker, the boot rotation, the glue on the barrel after the mortar rinse off. There shall be no water in the cylinder to prevent the barrel and the blade from rusting. At the same time should also be cleaned outside the mixing tube fouling, so that machinery to keep clean and intact.

Previous: Principle and Application of Biaxial Mixer

Next: No Information


    <li id="w4o44"></li>

    <th id="w4o44"><pre id="w4o44"><dl id="w4o44"></dl></pre></th>

      1. <progress id="w4o44"></progress>